650-4541-0002 (Manufacturer Part Number: 6504541 00 02) Color: Chrome
*The actual product may differ in some colors and shapes due to improvements and specification changes. *Junior/Flash 30/40, Alu Standard 35/40, Alu Standard Topcase 35, Xplorer 30/40, Xplorer Cutout 37/40, Xceed, Gobi, Journey 42, Pillions are not allowed when used.
Holders for mounting HEPCO&BECKER top and side cases. The top and side are integrated, and the holder has no unnecessary frame. All Hepco & Becker top cases can be installed. A special reinforced pipe with different properties is added to the pipe to create a double-layered structure. In addition, the joint point of the vehicle, which is made of thick-walled steel, has a structure with excellent impact resistance, which was derived through trial and error.
I finally bought it. It looks like it was ordered from Germany and it arrived about 3 weeks after I ordered it. The installation was done by looking at the German and English version of Copy's Manual. I had to look at the unclear picture of WhiteBlack to make a hole in it, but I managed it.
As you would expect from an expensive product, it seemed to be well made. I used to have a Daytona Carrier before I put this on, and it was a very good product, but if I skipped washing the car or something, it got pretty rusty and looked shabby. I'm going to be careful with this next one.
It's divided into 3 parts and assembled by Bolt, but when I hit it, the position is a little bit different and I had to tighten up to fit it, but that's probably how it is. It also bonds to the bolts where the license plate will be attached, which significantly reduces the vibration shake of the rear fender and license plate. After the installation, the rigidity around the rearRear Fender is clearly increased and it is extremely firm and secure, because SR400 has a large vibration.
There are quite a lot of drainage holes in each Pipe so that they are not noticeable. Is it to prevent the corrosion from inside? I think it is better to seal the holes to prevent corrosion, but I don't know how to do that.
There is a bar between the Top Carrier part and Seat. (Pannier) I only use it when I want to stand the Center Stand with it on. I don't have anywhere else to hang my hands, so this is very useful. Well, but I think I'd be complaining if it wasn't there. I'm not sure if this is a good idea.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!