Excellent
OEM styleWhat made you decide to buy?
I have already installed KIJIMA:Handlebar Mount Bracket on my ZX-6R, and I will install my smartphone and GoPro on Handlebar Mount Bracket as TouringItems. I decided to purchase this product to supply power to my smartphone and GoPro.
How was your experience with it?
I actually drove the car after installing it, and it did not interfere with driving, but it is prohibited to use in the rain. I do not intend to run when it rains except when I encounter rain on the road, but I want to pay attention to getting wet. When not using it, it is to install Rubber cap. In addition, the body shines in Blue with built-in LED, but I do not understand it because the surroundings are bright in the daytime (laugh).
What is the point of the installation work?
For this installation, the ZX-6R has "How to look like an OEM!" Installation was done to InnerCowling of Right Side. I did information gathering before purchasing, but it did not hit the information which I was seeking easily......it was only that there was Attachment power supply of OEM in Right Side which I was able to hit (sweat)
While the quantity of information was little, when it purchased, the commodity arrived, and the installation position confirmation was done. When the installation point is decided, it is the confirmation of the space at the time of the USB power supply body embedding. It is very important to have a space of 38.7mm or more when the USB power supply body is embedded. Also, in case of failure, you can find Kawasaki OEM Parts, Right SideInnerCowling on Webike. [55028-0676] I did a quote with them and the OEM Parts price was reasonable so I didn't mind and started the work.
The ZX-6R's Right SideInnerCowling has a subtle curved surface, and it is necessary to secure the mounting space. When a rough place is decided, masking tape is pasted, and the installation position is ruled with a pen. When the center is decided, Small Dr. If the center is decided, while changing the blade with Small Safty Drill, the preparatory hole of the center is opened, and the hole drilling of 28 is done with Reamer. When the preparation hole processing is completed, the quantity:Pair (for Left and Right) I recommend careful and careful work, and it is better to check the middle of the way.
After machining the bottom hole, install the USB power supply body. After installing the USB power supply body, temporarily adjust the body to check the wiring length and interference. Remove the USB power supply body from the car body, cut the wiring length to the required length, process the bullet terminal to prevent it from coming off, connect it to the OEMAttachment power supply wire on the car body side with the bullet terminal, and attach it to the car body in quantity.:Set and finish. Finally, it is operation check. Turn the key to ACC, connect the charging cable to the phone, and check the charging, and if it charges safely, it is good. Also, ZX-6R is severe around Handlebar.:Pair (for Left and Right) Is there any contact between the USB power supply body and the charging cable? Also, is there any load on the charging cable? Is it safe to use? Then, it is finished.View Detail